欧美大成色www永久网站婷,两个人视频免费

TranslationMobile

規定負荷

"given" in Chinese : adj. 1.一定的，特定的。 2.給予的，贈送的。 3 ...
"load" in Chinese : n. 1.裝載，擔子；負擔；工作(負荷)量。 2.(車船 ...
"be given" in Chinese : 受到
"be given to" in Chinese : 沉湎于; 喜歡, 癖好
"given" in Chinese : adj. 1.一定的，特定的。 2.給予的，贈送的。 3.〔數學推理等的獨立 ...
"given that" in Chinese : 只要是，考慮到；假定，已知
"given to" in Chinese : 慣于..
"to be given given under this" in Chinese : 應給予的通知
"a given area" in Chinese : 一定地區
"a given period" in Chinese : 一定時期
"at given speed" in Chinese : 達到給定速度
"be given credit for" in Chinese : 為…而受到稱贊，因…而受到表揚; 因…而受到表揚
"be given over to" in Chinese : 沉溺于; 使沉湎于, 使縱情于
"be given the title of" in Chinese : 被授予稱號
"be given to drink" in Chinese : 嗜酒成癖

Examples

In solving most stress problems it is first necessary to find the reactions that the given loading produces .
在解決多數的應力問題時，首先必須求出已知載荷產生的反力。
With the network , the effects of low - loading strengthening can be determined under given load and times of strengthening
對于給定的強化載荷和強化次數，應用構造的神經網絡模型，可以確定相應的低載強化效果。
This returns the given loaded config variable value . if no parameter is given , an array of all loaded config variables is returned
返回指定配置變量的值。如果不指定變量名稱，則會返回一個包含所有已加載配置變量的值的數組。
First , the paper designs the loading system on the basis of given loading data . then , it sets up the linear model of simulation and simulate
本文首先進行起落架加載系統的靜態參數設計并建立其線性化仿真模型，然后進行仿真。
You should generally run several runs with different step durations and step user counts so that you can get good measurements for a given load
通常應運行具有不同的單步持續時間和單步用戶計數的幾個運行，這樣在給定的負載下可以準確地衡量。
This returns the given loaded config variable value . if no parameter is given , an array of all loaded config variables is returned
此函式在傳回由組態檔載入的變數值。如果沒有使用任何參數的話，則所有經由組態檔載入的變數都會以陣列的形式傳回。
First , the loading system is designed on the basis of given loading data . then , the linear model of simulation is set up and simulated
首先根據用戶給定載荷及要求對系統進行設計，然后根據初步設計建立系統仿真模型，對多余力和加載曲線進行仿真。
3 , analyzing the stress field of the aero - engine case under the given loads , the fatigue life of the case is predicted through the presented fatigue model and the method of " nominal stress "
用該模型對孔徑為5mm層合板的s ? n曲線進行疲勞壽命預測及試驗驗證。 3 、首次對某型發動機t300 kh - 304復合材料機匣的主鋪層在給定工況下的疲勞壽命進行預測。
According to the behaviors of diagonally - loaded frames , effects of infill material property and frame stiffness on performance of infilled frames are investigated . 2 . based on result of lateral actions test , gives load - deflection curves for infilled frames
對斜向加載的墻板單元進行了試驗研究，分析了填充塊材料性能、框架梁柱剛度等因素對墻板單元力學性能的影響。
Based on the six - port relative power theory that for a given load the relative power ratios of different ports are left unchanged with the input power to the six - port varied , characteristic parameters of detectors can be obtained through the least - square method
根據六端口相對功率理論即對某一負載各端口相對功率比值不隨輸入功率變化，由最小二乘法得到檢波器的特征參數，結合四標準法，確定六端口網絡的系統常數。